PERFORMANCE, SAFETY, PEACE OF MIND
Run Flat tyres mean safety. They provide greater control of your car in emergency conditions and allow you to continue driving safely even during a rapid loss of inflation pressure.
With Run Flat, you will retain mobility in the event of a puncture. So, if your tyre is punctured, even in pouring rain, the Pirelli Self-Supporting Run Flat means you don't have to bother with the spare. Instead, you can continue driving for a limited period.
To ensure maximum safety during an emergency situation, the Run Flat tyre must maintain certain speed and distance parameters (80km/h for 80km or 50mph for 50 miles). Due to these restrictions, it's imperative that motorists be notified when a loss in tyre pressure occurs, and therefore the vehicle must be equipped with a TPMS (Tyre Pressure Monitoring System) to detect and signal tyre pressure changes.
Run Flat tyres have been developed based on the specifications of the vehicles on which they are mounted. Accordingly, Run Flat tyres may only be mounted on vehicles specifically manufactured to accommodate Run Flat tyres.
Run Flat tyres must be mounted in conjunction with a functional Tyre Pressure Monitoring System (TPMS). The mounting of tyres and installation of the TPMS should be carried out by a specialised dealer.
Pirelli certifies that after pressure loss, Run Flat tyres can continue to run for 80km (50 miles) at a maximum speed of 80km/h (50 mph). Always refer to the vehicle owner's manual for specific safety and operating information relating to the vehicle.
After the low pressure warning is shown, the condition of the remaining tyres and the TPMS should be checked immediately by a specialised dealer.
A tyre should always be changed and not repaired after a loss of pressure, as it is not always possible to establish the time and conditions under which the tyre has been used with insufficient inflation pressure.
Damaged Run Flat tyres, or Run Flat tyres that have experienced a loss of pressure should be replaced immediately with another Run Flat tyre of identical size and service description (Load Index and Speed Code). Pirelli recommends that a tyre of a different type, or which contains a different load index or speed code, should never be mounted on the same vehicle.
After a loss of pressure, the rims should be inspected to ensure they haven't been damaged. Damaged or deformed rims should always be replaced prior to mounting a new Run Flat tyre. Pirelli recommends the use of Extended Hump rims (EH2), which reduce the risk of bead unseating in case of loss of pressure.
Yes it is possible, although Pirelli strongly recommends that EH2 rims be used because they guarantee improved retention of the tyre bead down to zero inflation pressure. In the event of run flat operation at zero pressure with H2 rims, provided that a Pirelli self-supporting run flat tyre is used in conjunction with a Tyre Pressure Monitoring System (TPMS) or air pressure warning system, the tyre will maintain its run flat characteristics. A TPMS is absolutely necessary to alert the driver that the tyre has lost pressure.
Standard tyres can be fitted to EH2 rims but they will not have run flat features.
Pirelli does not recommend mixing run flat tyres and standard tyres on the same vehicle, even if paired in axle sets. If you have a puncture, the run flat tyres are designed to permit you to reach a tyre dealer where you can have the tyre checked and replaced if necessary with another run flat tyre. In exceptional and emergency circumstances a normal tyre with identical dimensions, load index and speed code can be fitted for a very limited period and distance. It must be noted that standard tyres do not have the same run flat characteristics as the other tyres on your vehicle and must be removed at the earliest opportunity.
Yes, but Pirelli recommends that in a run flat condition you should not exceed 80km (50 miles) at a maximum speed of 80km/h (50 mph). Pirelli strongly recommends that the different tyre brands should be fitted in axle sets and the tyre pressure monitoring system must be controlled to make sure that the pressure settings are compatible.
Run Flat tyres have been developed based on the specifications of the vehicles on which they are mounted. Accordingly, Run Flat tyres may only be mounted on vehicles specifically manufactured to accommodate Run Flat tyres, therefore you must contact the vehicle manufacturer if you are in doubt.
No, for safety reasons, Pirelli chooses not to recommend the repair of self-supporting run flat tyres. A self-supporting run flat tyre should always be changed and not repaired after a loss of pressure because it is not always possible to establish the time and conditions under which the tyre has been used with insufficient inflation pressure.
No. After a puncture you can only travel 80km (50 miles) at a maximum speed of 80km/h (50mph), following which the tyre must be replaced.
Provided the vehicle is operated within restricted run flat speed of 80km/h (50 mph), handling is only slightly impaired due to reduced cornering force. Aquaplaning and braking remain almost the same. It is recommended that you avoid sharp driving manoeuvres if a tyre is completely deflated, especially if the tyres are fitted to H2 standard rims.
No. The maximum condition guaranteed by Pirelli is 80km (50 miles) at zero pressure at a speed not exceeding 80km/h (50mph). For vehicles fitted with Pirelli self-supporting Run Flat tyres as original equipment, the tyre manufacturer's recommendations indicated in the owners manual apply.
There are a range of tyre pressure monitoring systems (TPMS) available so you should consult the vehicle manufacturer if you require a specific explanation. Basically there are two types of system, indirect systems use the fact that reduced air pressure causes the wheel to rotate at a slower speed and when they detect this difference send a warning to the driver. Direct systems directly control tyre pressure against pre-set values and send a warning when actual pressure falls below set values.
which appears on the sidewall of the tyre. On tyres specifically homologated for BMW vehicles there are also the letters RSC which stand for Run Flat System Component.
Pirelli guarantee a general maximum distance of 80km for all self-supporting run flat tyres. Vehicle manufacturers conduct their own tests based on specific vehicle models, taking into consideration vehicle weight and characteristics and can decide together with the tyre manufacturer can suggest an increased distance for that specific vehicle. For vehicles fitted with Pirelli self-supporting Run Flat tyres as original equipment, the tyre manufacturer's recommendations indicated in the owners manual apply.